Search Results

CPSC, Viessmann U.S. Recalls Boilers Due to Fire Hazard

The boiler can leak gas, posing a fire hazard to consumers....

CPSC, Portable Generators Recalled by General Power Products Due to Fire Hazard

The generator’s fuel valve can be damaged by the cover plate during shipment and cause a fuel leak and fuel spillage during use, posing a fire hazar...

CPSC, DEWALT Recalls Portable Generators Due to Electric Shock Hazard

A ground fault circuit interrupter (GFCI) installed on the generator could fail to operate properly, posing a risk of electric shock to consumers....

CPSC, DeWalt Recalls Framing Saws and Circular Saws for Laceration Hazard

The lower blade guard can fail to close, leaving the blade exposed and presenting a laceration hazard to consumers....

CPSC, Venmar CES Inc. Recalls Heat Recovery Ventilators Due to Fire Hazard

Recall of Venmar CES Light Commercial Heat Recovery Ventilators sold under several brands between January 1991 and July 2007. The units can overheat...

CPSC, MTD Southwest Inc. Recalls Troy-Built, Craftsman Chain Saws, Breaking Handles Pose Laceration Hazard

The chain saw’s plastic front handle can break during operation. If this occurs, the saw would be difficult to control and poses a risk for lacerati...

CPSC, Gardner Bender Recalls Electrical Wire Splices Due to Shock and Fire Hazards

Recall of wire splices – Model numbers 10-126 or 21-126, because they fail to hold wires together and can cause fires....

CPSC, Pressure Washers and Air Compressors Recalled by DeVilbiss Due to Fracture and Laceration Hazards

The pressure washers and air compressors have pneumatic tires with plastic hubs that can burst, posing a laceration or fracture hazard to consumers....

CPSC, Square D Recalls Safety Switches Due to Shock or Electrocution Hazard

The safety switch can continue to supply electricity even after being placed in the “OFF” position. This poses the risk of an electric shock or el...

CPSC, DeWALT Recalls Cordless Drills Due to Fire Hazards

Recall of cordless drill because the trigger switch can overheat on selected models – DC920, 930, 935, 936 and 940....