Search Results

Fire extinguisher inspection

This construction manager is checking an extinguisher housed in a job-built holder that meets OSHA's 1926.150(a)(3) requirement for firefighting equip...

First aid kit, infection control kit and airhorn

Station in construction trailer where first aid kit, infection control kit and air horn are located. The latter is used to warn everyone on site of an...

GFCI protection on jobsite

This electrical box on the construction site has ground fault circuit interrupters on all outlets to be used with portable equipment....

Guarding of floor hole

Proper guarding of a potentially deadly floor hole. Orange paint makes the guarding more prominent....

Lead paint removed from structural beam

The original structural beams in the older section of this facility had been painted with red lead (lead oxide) paint. A licensed lead paint abatement...

Sealed ducts

This duct has been sealed to prevent dust and fungal spores from getting into the HVAC system. This building is working towards LEED silver, which req...

U-Bolt properly applied

This U-Bolt has been properly applied because the strongest part is the clear rounded section that holds the dead end of the cable, which poses the gr...

Arc welding power sources with extinguisher near by

These arc welding units have an extinguisher nearby in case of fire....

Welder at heights tied off

This welder is doing flux-cored welding at heights, but is wearing fall protection and is tied off to the horizontal beam....

Maintenance employee at risk of falling

An obvious lack of fall protection while a maintenance employee is conversing with another worker three floors below him...