Search Results

Sealed ducts

This duct has been sealed to prevent dust and fungal spores from getting into the HVAC system. This building is working towards LEED silver, which req...

Arc welding with grounding

This welder is performing flux-cored welding. The box contains the spool of consumable metal and the operation is grounded....

U-Bolt properly applied

This U-Bolt has been properly applied because the strongest part is the clear rounded section that holds the dead end of the cable, which poses the gr...

Arc welding power sources with extinguisher near by

These arc welding units have an extinguisher nearby in case of fire....

Welder at heights tied off

This welder is doing flux-cored welding at heights, but is wearing fall protection and is tied off to the horizontal beam....

Welder with double lanyards

This arc welder is wearing dual retractable lanyards that allow him to always stay attached to a lifeline while moving about near the perimeter....

Cable guardrails around holes

Cables have been strung through angle iron at the proper upper and midrail height around dangerous floor holes. Danger tape provides warning that the...

Fire extinguisher inspection

This construction manager is checking an extinguisher housed in a job-built holder that meets OSHA's 1926.150(a)(3) requirement for firefighting equip...

First aid kit, infection control kit and airhorn

Station in construction trailer where first aid kit, infection control kit and air horn are located. The latter is used to warn everyone on site of an...