This graphic is one of five taken from an infographic created by CPWR. The data for this graphic came from a poster presentation by CPWR's Data Center...
This infographic is based on data from CPWR's Construction Chartbook and from www.StopConstructionFalls.com. The data are presented in easy to underst...
This NIOSH Prevention Through Design (PtD) guidance addresses preventing falls through designing embedded safety features into projects. This guidance...
This short, but excellent guide from OSHA describes two preventable fatalities, one a fall from a tree and the other a struck-by falling branch incide...
Cables have been strung through angle iron at the proper upper and midrail height around dangerous floor holes. Danger tape provides warning that the...
Proper guarding of a potentially deadly floor hole. Orange paint makes the guarding more prominent....
This U-Bolt has been properly applied because the strongest part is the clear rounded section that holds the dead end of the cable, which poses the gr...
This welder is doing flux-cored welding at heights, but is wearing fall protection and is tied off to the horizontal beam....
This arc welder is wearing dual retractable lanyards that allow him to always stay attached to a lifeline while moving about near the perimeter....
Metabo announced a recall of their W14-150 Ergo Angle Grinders because under certain conditions, the on/off switch can stick in the on position. Two...