Search Results

OSHA Plans to Rescind Compliance Directive on Fall Protection Under Steel Erection Rule

BNA reports OSHA rescinding a fall protection compliance directive in response to advice from ACCSH....

225

Unsupported scaffold boards, scaffold access ladder too short. Blocks falling off scaffold, scaffold in rear may be overloaded....

LOHP Tailgate Meeting Introduction

An overview page of the Labor Occupational Health Program Tailgate Meetings That Work. There are several collections on different topics in this progr...

224

Ladders not sufficiently supported at base. Ladder jacks are not supposed to exceed 20 feet,1926.452(k)....

Protection From Electric Shock and Arc Flash

Discussion of the electric hazards posed to electrical workers, describes the nature of the hazards and steps that can be taken to improve safety....

Cranes, Derricks, Hoists, Elevators, and Conveyors-Subpart N Section 6

An in-depth presentation on regulations covering cranes, derricks, helicopters, hoists, and conveyors, hazards commonly seen while using them and a qu...

872

Any walking working surface that is being used as a scaffold must comply with the OSHA scaffold regulations. Scaffold is inadequately planked, has no...

904

Never use a ladder and stilts....

767

Working on top step of ladder, Potential shock hazard, spliced extension cord. Most extension cords are 14 to 16 gage. OSHA will only allow a 12 gage...

898

No fall protection. Step ladder is being used incorrectly. There should be an established fall arrest system...