Search Results

TBT5 Manual Tools

This is the fifth in a series of 6 tool box talks on construction ergonomics produced by the University of Washington in St. Louis. This one focuses o...

TBT6 Power Tools

This is the last in the series of 6 tool box talks created by Washington University in St. Louis on the subject of ergonomics in construction. This on...

TBT1 Ergonomics in Construction

This is the first in a series of 6 Tool Box Talks produced by Washington University in St. Louis on ergonomics in construction work. This one should b...

TBT2 Keep Reach Close

This is the second of six Tool Box Talks created by Washington University in St. Louis on ergonomics in construction. There is a guide with the series...

TBT3 Positioning

This third in a series of 6 Tool Box Talks on construction ergonomics focuses on proper positioning to avoid injuries. The TBT recommends: 1)prop up a...

U-Bolt properly applied

This U-Bolt has been properly applied because the strongest part is the clear rounded section that holds the dead end of the cable, which poses the gr...

Fire extinguisher inspection

This construction manager is checking an extinguisher housed in a job-built holder that meets OSHA's 1926.150(a)(3) requirement for firefighting equip...

First aid kit, infection control kit and airhorn

Station in construction trailer where first aid kit, infection control kit and air horn are located. The latter is used to warn everyone on site of an...

GFCI protection on jobsite

This electrical box on the construction site has ground fault circuit interrupters on all outlets to be used with portable equipment....

Guarding of floor hole

Proper guarding of a potentially deadly floor hole. Orange paint makes the guarding more prominent....